Installing An Mx480 Switch Control Board; Figure 143: Removing A Switch Control Board From The Mx480 - Juniper MX480 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
Rotate the ejector handles simultaneously counterclockwise to unseat the Switch
4.
Control Board.
Grasp the ejector handles, and slide the Switch Control Board about halfway out of
5.
the chassis.
Place one hand underneath the Switch Control Board to support it, and slide it
6.
completely out of the chassis.
Place the Switch Control Board on the antistatic mat.
7.
If you are not replacing the Switch Control Board now, install a blank panel over the
8.
empty slot.

Figure 143: Removing a Switch Control Board from the MX480

Installing an MX480 Switch Control Board

Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Carefully align the sides of the Switch Control Board with the guides inside the chassis.
2.
Slide the Switch Control Board into the chassis until you feel resistance, carefully
3.
ensuring that it is correctly aligned.
Grasp both ejector handles, and rotate them simultaneously clockwise until the Switch
4.
Control Board is fully seated.
Chapter 4: Maintaining Components
333