Installing An Mx480 Dual-Wide Mic; Figure 123: Installing A Mic - Juniper MX480 Hardware Manual

See Also
Copyright © 2019, Juniper Networks, Inc.
Press the MIC offline/online button until the MIC
Issue the following CLI command:
user@host> request chassis mic fpc-slot mpc-slot mic-slot mic-slot online
For more information about the command, see the
The normal functioning status LED confirms that the MIC is online. You can also verify
correct MIC functioning by issuing the
in "Maintaining MX480 MICs" on page

Figure 123: Installing a MIC

MX480 Modular Interface Card (MIC) Description on page 112
Troubleshooting the MX480 MICs on page 360
MX480 MIC Serial Number Label on page 373

Installing an MX480 Dual-Wide MIC

To install a dual-wide MIC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Remove the septum, if necessary (see
2.
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in "Removing an MX480 MPC" on page
Remove the four screws labeled
b.
Remove the two screws labeled
c.
Slide the septum towards you and out of the MPC.
d.
Store the septum and screws for later use.
e.
Install the MPC as described in
f.
OK/FAIL
CLI Explorer
show chassis fpc pic-status
288.
Figure 125 on page 295):
Figure 124 on page
298).
S on the bottom of the MPC.
S on the top of the MPC.
"Installing an MX480 MPC" on page
Chapter 4: Maintaining Components
LED lights green.
.
command described
294):
300.
293