Mx480 Chassis Lifting Guidelines; Ramp Warning - Juniper MX480 Hardware Manual

MX480 Universal Routing Platform Hardware Guide

MX480 Chassis Lifting Guidelines

Related
Documentation

Ramp Warning

390
The weight of a fully configured chassis is about 163.5 lb (74.2 kg). Observe the following
guidelines for lifting and moving the router:
Before moving the router, verify that the intended site meets the specified power,
environmental, and clearance requirements.
Do not attempt to lift a fully configured router by yourself. Using a mechanical lift to
maneuver the router into a rack is recommended. If a lift cannot be used, a minimum
of two people must lift the router, and you must remove components from the chassis
before lifting.
To lift routing devices and components, use the following lifting guidelines:
Up to 39.7 lbs (18 kg) 1 person lift.
39.7 lbs (18 kg) to 70.5 lbs (32 kg) 2 or more person lift.
70.5 lbs (32 kg) to 121.2 lbs (55 kg) 3 or more person lift.
Above 121.2 lbs (55 kg) material handling systems (such as levers, slings, lifts and
so on) must be used. When this is not practical, specially-trained persons or systems
must be used (riggers or movers).
Before lifting or moving the router, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
MX480 Site Preparation Checklist on page 139
Removing Components from the MX480 Router Before Installing It Without a Lift on
page 190
Installing the MX480 Chassis in the Rack Manually on page 196
WARNING: When installing the device, do not use a ramp inclined at more
than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10
graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Copyright © 2019, Juniper Networks, Inc.