Replacing The Mx480 Cable Management Brackets; Figure 86: Removing The Cable Management Brackets - Juniper MX480 Hardware Manual

Replacing the MX480 Cable Management Brackets

Copyright © 2019, Juniper Networks, Inc.
To remove the cable management brackets (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Loosen the captive screws on either side of the chassis.
2.
Remove the cable management brackets.
3.
To install the cable management brackets (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Position the on the front sides of the chassis.
2.
Insert the tabs into the slots.
3.
Tighten the screws completely.
4.

Figure 86: Removing the Cable Management Brackets

Slot
Tab
Chapter 4: Maintaining Components
Figure 86 on page 231):
Figure 86 on page 231):
Screws
231