Figure 53: Installing The Router In The Rack - Juniper MX480 Hardware Manual

MX480 Universal Routing Platform Hardware Guide
See Also
184
Slide the router onto the mounting shelf until the mounting brackets contact the rack
6.
rails. The shelf ensures that the holes in the mounting brackets of the chassis align
with the holes in the rack rails.
Move the lift away from the rack.
7.
Install a mounting screw into each of the open mounting holes aligned with the rack,
8.
starting from the bottom.
Visually inspect the alignment of the router. If the router is installed properly in the
9.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side and the router should be level.

Figure 53: Installing the Router in the Rack

NOTE: This illustration depicts the router being installed in an open-frame
rack. For an illustration of the mounting hardware required for a four-post
rack or cabinet.
MX480 Site Preparation Checklist on page 139
Copyright © 2019, Juniper Networks, Inc.