Lift; Figure 60: Removing The Fan Tray - Juniper MX480 Hardware Manual

MX480 Universal Routing Platform Hardware Guide
192
Press the latch located on the inside of the fan tray to release it from the chassis.
4.
Place one hand under the fan tray to support it, and pull the fan tray completely out
5.
of the chassis.

Figure 60: Removing the Fan Tray

Removing the SCBs Before Installing the MX480 Router Without a Lift
To remove the SCBs (see Figure 61 on page
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Rotate the ejector handles simultaneously counterclockwise to unseat the SCB.
3.
Grasp the ejector handles, and slide the SCB about halfway out of the chassis.
4.
Place one hand underneath the SCB to support it, and slide it completely out of the
5.
chassis. Place it on the antistatic mat.
193):
Copyright © 2019, Juniper Networks, Inc.