Scb Leds On The Mx480 Craft Interface; Fan Leds On The Mx480 Craft Interface; Mx480 Cable Management Brackets; Table 10: Fpc Leds On The Craft Interface - Juniper MX480 Hardware Manual

MX480 Universal Routing Platform Hardware Guide

MX480 Cable Management Brackets

40

Table 10: FPC LEDs on the Craft Interface

Label Color
Green
OK
–
Red
FAIL

SCB LEDs on the MX480 Craft Interface

Each SCB has two LEDs on the craft interface that indicates its status. The SCB LEDs,
labeled and , are located along the bottom of the craft interface.
0 1
describes the functions of the SCB LEDs.

Table 11: SCB LEDs on the Craft Interface

Label Color
Green
OK
–
Red
FAIL

Fan LEDs on the MX480 Craft Interface

The fan LEDs are located on the top left of the craft interface.
describes the functions of the fan LEDs.

Table 12: Fan LEDs on the Craft Interface

Label Color
Green
FAN
Red
The cable management brackets (see
consist of plastic dividers located on the left and right sides of each DPC, FPC, or MPC
slot, and SCB slot. The cable management brackets allow you to route the cables outside
the router and away from the DPCs, MPCs, MICs, PICs, and SCBs.
State Description
On steadily FPC is functioning normally.
Blinking FPC is transitioning online or offline.
Off The slot is not online.
On steadily FPC has failed.
State Description
On steadily SCB: Fabric and control board functioning normally.
Blinking SCB is transitioning online or offline.
Off The slot is not online.
On steadily SCB has failed.
State Description
On steadily Fan is functioning normally.
On steadily Fan has failed.
Figure 6 on page 41
Table 11 on page 40
Table 12 on page 40
and Figure 7 on page 41)
Copyright © 2019, Juniper Networks, Inc.