Tools Required To Install The Mx480 Router Without A Mechanical Lift; Lift; Figure 58: Reinstalling An Fpc - Juniper MX480 Hardware Manual

MX480 Universal Routing Platform Hardware Guide
See Also

Tools Required to Install the MX480 Router Without a Mechanical Lift

Removing Components from the MX480 Router Before Installing It Without a Lift
190

Figure 58: Reinstalling an FPC

Preventing Electrostatic Discharge Damage to an MX480 Router on page 388
To install the router, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) nut driver
ESD grounding wrist strap
If you cannot use a mechanical lift to install the router (the preferred method), you can
install it manually. To make the router light enough to install manually, you first remove
most components from the chassis. The procedures for removing components from the
chassis are for initial installation only, and assume that you have not connected power
cables to the router. The following procedures describe how to remove components from
the chassis, first from the rear and then from the front:
Removing the Power Supplies Before Installing the MX480 Router Without a
1.
Lift on page 191
Removing the Fan Tray Before Installing the MX480 Router Without a Lift on page 191
2.
Removing the SCBs Before Installing the MX480 Router Without a Lift on page 192
3.
4. Removing the DPCs Before Installing the MX480 Router Without a Lift on page 193
Removing the FPCs Before Installing the MX480 Router Without a Lift on page 194
5.
M X4 80
Copyright © 2019, Juniper Networks, Inc.