Service Diagnostics Tests - Xerox Phaser 6300 Service Manual

Service Diagnostics Tests

Service Diagnostics Tests and Utilities
Test
Print Service Menu Map
General Status - Provides the following print engine status:
General Engine
Status
Engine Board ROM
Version
Printer
Configuration
Ambient
Temperature/
Humidity
Fuser Temperature
Fault History
Test Prints - Prints test prints stored in the Engine Control Board.
Blank Page Print
Standard Test Print
Custom Test Print
Current Custom
Test Print Setup
Custom Test Print
Parameters
Reference
Control Panel Display and Test Definition
- Prints the Service Diagnostics menu then exits diagnostic mode.
No Status To Report
-or one or more
Printer Status Messages (page A-4)
NOTE: This is current non-
sequential status since
entering diagnostics. If
Ready is reached, Status is
cleared.
Engine FW: #.#.# or Unknown
Engine NVRAM: #.#.# or Unknown
Option Feeder: #.#.# or Unknown
Memory: ###MB
Hard Drive: Not Installed or Installed
HCF/LTA: Installed or Not Installed
o
Temperature: ## C
o
Temperature: ## F
Humidity: ## %
o
Temperature: ## C
o
Temperature: ## F
Fault History Display
Fault History Master Clear
List Cleared
Continuously prints blank pages until
Cancel is pressed.
Continuously prints the Step pattern
until Cancel is pressed.
Prints the test pattern using the
custom print parameters until
Cancel is pressed.
Displays the print setup for the
Current Test Print.
Set Custom Test Print parameters.
No Status to Report = the printer
is online and ready to print.
Displays an engine status that will
prevent printing. Status is
displayed one line at a time.
Displays the engine/feeder
firmware version installed, if
known.
Displays current memory installed.
Detects presence of Hard Drive.
Detects presence of option feeder.
Reboot printer to update option
status. Do not lift engine from
optional tray to test.
Displays the current Temperature
and Humidity for the printer.
Displays the printer's current Fuser
temperature.
Displays Fault occurrence since
last power cycle. Cycle Power
displays following Master Clear.
See "Test Prints" on page 5-4,
"Adjustments" on page 6-3, and
"Resetting NVRAM" on page 6-4,
for specific test print information.
A-11