Add/Edit A Protocol Based Vlan - ZyXEL Communications XS3800-28 User Manual

57.11.1 Add/Edit a Protocol Based VLAN

Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > VLAN > Protocol Based VLAN
Setup screen to display this configuration screen.
Figure 326 SWITCHING > VLAN > Protocol Based VLAN Setup > Add/Edit (Standalone Mode)
Figure 327 SWITCHING > VLAN > Protocol Based VLAN Setup > Add/Edit (Stacking Mode)
The following table describes the labels in this screen.
Table 209 SWITCHING > VLAN > Protocol Based VLAN Setup > Add/Edit
LABEL
Active
Port
Name
Ethernet-type
VID
Priority
Chapter 57 VLAN
DESCRIPTION
Enable the switch button to activate this protocol based VLAN.
Type a port number to be included in this protocol based VLAN. In Stacking mode, the first
box field is the slot ID and the second field is the port number.
This port must belong to a static VLAN in order to participate in a protocol based VLAN.
Enter up to 32 alphanumeric characters to identify this protocol based VLAN. The string
should not contain [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Use the drop down list box to select a predefined protocol to be included in this protocol
based VLAN or select Other and type the protocol number in hexadecimal notation. For
example the IP protocol in hexadecimal notation is 0800, and Novell IPX protocol is 8137.
Note: Protocols in the hexadecimal number range of 0x0000 to 0x05ff are not
allowed to be used for protocol based VLANs.
Enter the ID of a VLAN to which the port belongs. This must be an existing VLAN which you
defined in the SWITCHING > VLAN > VLAN Setup > Static VLAN screen.
Select the priority level that the Switch will assign to frames belonging to this VLAN.
XS3800-28 User's Guide
430