ZyXEL Communications XS3800-28 User Manual page 66

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Figure 38 Wizard > Basic Settings > Step 2 Password

Note: The input string of any field in this screen should not contain [ ? ], [ | ], [ ' ], [ " ], or [ , ]. In

the Password fields, [ space ] is also not allowed.

Each field is described in the following table.

Table 11 Wizard > Basic Settings > Step 2 Password

Administrator's Password

Enter the existing system password (1234 is the default password when shipped).

New password

Enter your new system password. Up to 32 printable ASCII characters are allowed for the

new password.

Re-enter your new system password for confirmation.

Select Enabled to let the Switch act as an SNMP agent, which allows a manager station to

manage and monitor the Switch through the network. Select Disabled to turn this feature

Select the SNMP version for the Switch. The SNMP version on the Switch must match the

version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or both

Note: SNMP version 2c is backwards compatible with SNMP version 1.

Get Community

Enter the Get Community string, which is the password for the incoming Get- and

GetNextrequests from the management station.

The Get Community string is only used by SNMP managers using SNMP version 2c or lower.

Set Community

Enter the Set Community string, which is the password for the incoming Set- requests from

the management station.

The Set Community string is only used by SNMP managers using SNMP version 2c or lower.

Chapter 4 Web Configurator

XS3800-28 User's Guide

Troubleshooting