Subnet Based Vlans - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Figure 320 SWITCHING > VLAN > VLAN Setup > GVRP (Stacking Mode)

The following table describes the labels in this screen.

Table 205 SWITCHING > VLAN > VLAN Setup > GVRP

57.8 Subnet Based VLANs

Subnet based VLANs allow you to group traffic into logical VLANs based on the source IP subnet you

specify. When a frame is received on a port, the Switch checks if a tag is added already and the IP

Chapter 57 VLAN

GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for

switches to register necessary VLAN members on ports across the network.

Enable the switch button to permit VLAN groups beyond the local Switch.

This field appears only in Stacking mode. Click the drop-down list to choose the slot number of

the Switch in a stack.

This field displays the port number of the Switch. In Stacking mode, the first number represents

the slot ID and the second is the port number. Please note that the default stacking ports (the

last four ports of your Switch) cannot be configured. They are reserved for stacking only.

Settings in this row apply to all ports.

Use this row only if you want to make some settings the same for all ports. Use this row first to set

the common settings and then make adjustments on a port-by-port basis.

Note: Changes in this row are copied to all the ports as soon as you make them.

Select this check box to allow GVRP on this port.

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to

save your changes to the non-volatile memory when you are done configuring.

Click Cancel to begin configuring this screen afresh.

XS3800-28 User's Guide