ZyXEL Communications XS3800-28 User Manual page 519

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Figure 412 NEWTORKING > Policy Routing > Policy Route Rule > Add/Edit

The following table describes the labels in this screen.

Table 278 NEWTORKING > Policy Routing > Policy Route Rule > Add/Edit

Profile Name

This field displays the policy routing profiles you configure in the NETWORKING > Policy Routing >

Policy Route Profile screen.

Select a profile for which you want to configure a policy routing rule.

Enter the rule number from 1 to 64. The ordering of your rules is important as rules are applied in

You can not specify a number already in use by another rule.

Select Permit to forward traffic that matches this rule to the gateway specified in the rule.

Select Deny to disable the rule action and forward traffic that matches this rule according to

the routing table on the Switch.

This field displays the available active classifiers you configure in the SECURITY > ACL > Classifier

screen, which are not used by any policy rule or policy routing rule.

Select a classifier to which this policy routing rule applies.

Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch that

will forward the packet to the destination.

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to

save your changes to the non-volatile memory when you are done configuring.

Click Clear to clear the fields to the factory defaults.

Click Cancel to not save the configuration you make and return to the last screen.

Chapter 68 Policy Routing

XS3800-28 User's Guide

Troubleshooting