Add/Edit Wol Relay - ZyXEL Communications XS3800-28 User Manual

61.2.1 Add/Edit WoL Relay

Use this screen to add or edit configurations on Wake On LAN relay. Click Add/Edit, or select an entry
and click Add/Edit in the SWITCHING > WoL Relay screen to open this screen.
Figure 355 SWITCHING > WoL Relay > Add/Edit
The following table describes the labels in this screen.
Table 230 SWITCHING > WoL Relay > Add/Edit
LABEL
UDP Port
Source VLAN
Destination VLAN
Apply
Clear
Cancel
Chapter 61 WoL Relay
DESCRIPTION
Enter a UDP port number that magic packets are sent through.
The most common port for transmission is UDP port 9.
Enter the source VLAN ID where the magic packet originates from.
Enter the destination VLAN ID where the magic packet will be sent to.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XS3800-28 User's Guide
459