Destination - ZyXEL Communications XS3800-28 User Manual

The following table describes the labels in this screen.
Table 128 SWITCHING > Mirroring > RMirror > Source > Add/Edit
LABEL
RMirror VLAN ID
Priority
Active
Reflector Port
SLOT
Port
*
Mirrored
Direction
Apply
Clear
Cancel

43.5 Destination

Use this screen to view and specify the RMirror VLAN and configure the monitor port when the Switch is
the destination device in remote port mirroring.
Click SWITCHING > Mirroring > RMirror > Destination to display the following screen.
Figure 213 SWITCHING > Mirroring > RMirror > Destination (Standalone Mode)
Chapter 43 Mirroring
DESCRIPTION
Select the RMirror VLAN over which the mirrored traffic is forwarded.
Enter the priority of the mirrored traffic.
Enable the switch button to enable the specified reflector port.
Enter the number of reflector port that adds the RMirror VLAN tag to all mirrored traffic and
forwards traffic to the connected ports in the same RMirror VLAN.
In Stacking mode, the first box field is the slot ID and the second field is the port number.
This field appears only in Stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
This field displays the port number. In Stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last
four ports of your Switch) cannot be configured. They are reserved for stacking only.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this option to mirror the traffic on a port.
Specify the direction of the traffic to mirror by selecting from the drop-down list box.
Choices are Egress (outgoing), Ingress (incoming) and Both.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XS3800-28 User's Guide
299