Pppoe Ia Port Vlan - ZyXEL Communications XS3800-28 User Manual

Table 165 SWITCHING > PPPoE Intermediate Agent > PPPoE IA Port (continued)
LABEL
Circuit-ID
Remote-ID
Apply
Cancel

47.4 PPPoE IA Port VLAN

Use this screen to configure PPPoE IA settings that apply to a specific VLAN on a port.
Click SWITCHING > PPPoE Intermediate Agent > PPPoE IA Port VLAN to display the screen as shown.
Figure 260 SWITCHING > PPPoE Intermediate Agent > PPPoE IA Port VLAN (Standalone Mode)
Chapter 47 PPPoE
DESCRIPTION
Enter a string of up to 63 ASCII characters (except [ ? ], [ | ], [ ' ], [ " ], or [ , ]) that the Switch adds
into the Agent Circuit ID sub-option for PPPoE discovery packets received on this port. Spaces
are allowed.
The Circuit ID you configure for a specific VLAN on a port (in the SWITCHING > PPPoE
Intermediate Agent > PPPoE IA Port VLAN screen) has the highest priority.
Enter a string of up to 63 ASCII characters (except [ ? ], [ | ], [ ' ], [ " ], or [ , ]) that the Switch adds
into the Agent Remote ID sub-option for PPPoE discovery packets received on this port. Spaces
are allowed.
If you do not specify a string here or in the Remote-ID field for a VLAN on a port, the Switch
automatically uses the PPPoE client's MAC address.
The Remote ID you configure for a specific VLAN on a port (in the SWITCHING > PPPoE
Intermediate Agent > PPPoE IA Port VLAN screen) has the highest priority.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS3800-28 User's Guide
350