Networked Av Mode Wizard; Basic Settings - ZyXEL Communications XS3800-28 User Manual

Table 9 ZON Utility Fields (continued)
LABEL
IP Address
System Name
Location
Status
Controller Discovery
Serial Number
Hardware Version
IPv6 Address

4.4 Networked AV Mode Wizard

The Setup Wizard can be accessed using the following methods:
• When the Switch is in its factory-default state, selecting Networked AV mode will automatically
access the Setup Wizard.
• When in Networked AV mode, click the Wizard link to access the Setup Wizard.
Figure 36 Wizard Link in Networked AV Mode
The Setup Wizard contains the following parts:
• Use the Basic Settings when networked AV service runs on management VLAN, using the combo/
fiber port for inter-switch connection.
• Use the Advanced Settings when you need to specify the VLAN for networked AV service and
configure the port's role manually.

4.4.1 Basic Settings

In Basic Settings, you can set up IP or DNS, set up your password, SNMP community, accept or skip the
default Networked AV mode settings, and view finished results.
In order to set up your IP or DNS, please do the following. Click Wizard > Basic Settings > Next > Step 1 IP
to access this screen.
Chapter 4 Web Configurator
DESCRIPTION
This field displays the IP address of an internal interface on the discovered device that
first received a ZDP discovery request from the ZON Utility.
This field displays the system name of the discovered device.
This field displays where the discovered device is.
This field displays whether changes to the discovered device have been done
successfully. As the Switch does not support IP Configuration, Renew IP address and
Flash Locator LED, this field displays "Update failed", "Not support Renew IP address"
and "Not support Flash Locator LED" respectively.
This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it is enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it will go
into the Nebula cloud management mode.
Enter the admin password of the discovered device to display its serial number.
This field displays the hardware version of the discovered device.
This field displays the IPv6 address on the discovered device that first received a ZDP
discovery request from the ZON Utility.
XS3800-28 User's Guide
64