Edit An Ipv6 Neighbor Discovery - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Figure 116 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Neighbor Discovery Setup

The following table describes the labels in this screen.

Table 59 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Neighbor Discovery Setup

DAD Attempts

24.7.1 Edit an IPv6 Neighbor Discovery

Use this screen to configure neighbor discovery settings for each interface. Select an entry and click Edit

in the SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Neighbor Discovery Setup screen to display this

Figure 117 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Neighbor Discovery Setup > Edit

The following table describes the labels in this screen.

Table 60 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Neighbor Discovery Setup > Edit

DAD Attempts

Chapter 24 IPv6

This is the interface index number.

This is the name of the IPv6 interface you created.

This field displays the number of consecutive neighbor solicitations the Switch sends for this

This field displays the time interval (in milliseconds) at which neighbor solicitations are re-sent for

this interface.

This field displays how long (in milliseconds) a neighbor is considered reachable for this interface.

Select an entry's check box to select a specific entry.

Click Edit to edit the selected entry.

Select the IPv6 interface you want to configure.

The Switch uses Duplicate Address Detection (DAD) with neighbor solicitation and advertisement

messages to check whether an IPv6 address is already in use before assigning it to an interface.

Specify the number of consecutive neighbor solicitations (from 0 to 600) the Switch sends for this

interface. Enter 0 to turn off DAD.

XS3800-28 User's Guide