System; What You Can Do; Cloud Management - ZyXEL Communications XS3800-28 User Manual

Table 371 MONITOR > System Information (continued)
LABEL
Threshold
Power Source
Status

88.7 SYSTEM

The following sections introduces the SYSTEM screens.

88.8 What You Can Do

• Use the Cloud Management screen
enable/disable NCC Discovery.
• Use the General Setup screen
system name and time.
• Use the IP Setup screen
default domain name server and add IP domains.
• Use the Logins screen
passwords for up to four users and set their privilege level.
• Use the SNMP screen
Management Protocol) settings.
• Use the SNMP User screen
managers using SNMP v3 and associate them to SNMP groups.
• Use the SNMP Trap Group screen
should be sent to each SNMP manager.
• Use the SNMP Trap Port screen
ports would be sent to the SNMP manager.

88.9 Cloud Management

The Zyxel Nebula Control Center (NCC) is a cloud-based network management system that allows you
to remotely manage and monitor Zyxel Nebula APs, Ethernet switches and security gateways.
The Switch is managed and provisioned automatically by the NCC (Nebula Control Center) when:
• It is connected to the Internet.
• The Nebula Control Center Discovery feature is enabled.
Chapter 88 Networked AV Mode
DESCRIPTION
This field displays the percentage tolerance of the voltage with which the Switch still works.
This field lists the power supply modules installed in the Switch. PSU_1 is PWR1, and PSU_2 is PWR2.
Active indicates the Switch is currently operating from the power source to which the power
module is connected.
Standby indicates the power module is connected to a power source but the Switch is NOT
operating from it.
N/A is displayed when the power module is not connected to a power source and there is no
available power.
(Section 88.9 on page
(Section 88.10 on page
(Section 88.11 on page
(Section 88.12 on page
(Section 88.13 on page
(Section 88.14 on page
(Section 88.15 on page
(Section 88.16 on page
XS3800-28 User's Guide
696) to view NCC Connection status and
698) to configure general settings such as the
700) to configure the default gateway device, the
702) to change the system password, configure
704) to configure your SNMP (Simple Network
706) to create SNMP users for authentication with
708) to specify the types of SNMP traps that
709) to set whether a trap received on the
696