Add/Edit A Policy Routing Profile; Policy Routing Rule Configuration - ZyXEL Communications XS3800-28 User Manual

The following table describes the labels in this screen.
Table 275 NETWORKING > Policy Routing > Policy Route Profile
LABEL
Index
Active
Profile Name
Add/Edit
Delete

68.2.1 Add/Edit a Policy Routing Profile

Click Add/Edit, or select an entry and click Add/Edit in the NETWORKING > Policy Routing > Policy Route
Profile screen to display this screen. Use this screen to add/edit a policy routing profile, which can consist
of multiple policy routing rules.
Figure 410 NETWORKING > Policy Routing > Policy Route Profile > Add/Edit
The following table describes the labels in this screen.
Table 276 NETWORKING > Policy Routing > Policy Route Profile > Add/Edit
LABEL
Active
Profile Name
Apply
Clear
Cancel

68.3 Policy Routing Rule Configuration

Use this screen to view and configure a policy route to override the default (shortest path) routing
behavior and forward packets based on the classifier and action you specify. A policy route rule defines
the matching classifier and the action to take when a packet meets the criteria in the classifier. The
action is taken only when all the criteria are met. Policy-based routing is applied to incoming packets on
a per interface basis before normal routing. The Switch does not perform normal routing on packets that
match any of the policy routes.
Chapter 68 Policy Routing
DESCRIPTION
This field displays the index number of the policy routing profile.
This field displays whether the policy routing profile is activated or not.
This field displays the descriptive name for this profile. This is for identification purposes only.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
DESCRIPTION
This field allows you to activate or deactivate this policy routing profile and rules in the profile.
Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ])
for identification purposes. Spaces are allowed.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XS3800-28 User's Guide
517