Configuring Ipv4 Rip - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Table 279 Default Distance Value (continued)

ROUTE SOURCE

69.2 Configuring IPv4 RIP

Click NETWORKING > RIP > IPv4 RIP in the navigation panel to display the screen as shown. You cannot

manually configure a new entry. Each entry in the table is automatically created when you configure a

new IP domain in the SYSTEM > IP Setup screen.

Figure 413 NETWORKING > RIP > IPv4 RIP

The following table describes the labels in this screen.

Table 280 NETWORKING > RIP > IPv4 RIP

ADMINISTRATIVE DISTANCE

Enable the switch button to enable IPv4 RIP on the Switch.

Enter a number from 10 to 255 to specify the administrative distance that is assigned to routes

learned by RIP.

The lower the administrative distance value is, the more preferable the routing protocol is.

Note: You cannot set two routing protocols to have the same administrative distance.

This field displays the index number of an IP interface.

Settings in this row apply to all entries.

Use this row only if you want to make some settings the same for all entries. Use this row first to set the

common settings and then make adjustments on a per entry basis.

Note: Changes in this row are copied to all the entries as soon as you make them.

This field displays the IP interface configured on the Switch.

Refer to the section on IP Setup for more information on configuring IP domains.

Select the RIP direction from the drop-down list box. Choices are Outgoing, Incoming, Both and

Select the RIP version from the drop-down list box. Choices are RIP-1, RIP-2B and RIP-2M.

XS3800-28 User's Guide

Chapter 69 RIP