Service Register - ZyXEL Communications XS3800-28 User Manual

Figure 548 MAINTENANCE > Reboot System (Stacking Mode)
Click the Config 1, Config 2, Factory Default, or Custom Default (or Stacking Default in Stacking mode)
1
button to reboot and load that configuration file. The confirmation screen displays.
Figure 549 Reboot Confirmation
Click YES and then wait for the Switch to restart. This takes up to 2 minutes.
2
Click Config 1 and follow steps 1 to 2 to reboot and load configuration one on the Switch.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
Click Stacking Default and follow steps 1 to 2 to reboot and load stacking default configuration settings
on the Switch. The master Switch login information will not be reset.
Click Factory Default and follow steps 1 to 2 to reboot and load Zyxel factory default configuration
settings on the Switch.
Click Custom Default and follow steps 1 to 2 to reboot and load a customized default file on the Switch.
This will save the custom default configuration settings to both Configuration 1 and Configuration 2.
Note: If a customized default file was not saved, clicking Custom Default loads the factory
default configuration on the Switch.

87.17 Service Register

Switch requires a license to use certain services. You can register your Switch and manage Switch
licenses at www.myzyxel.com.
See Table 1 on page 31
Note: You can configure licensed features without a license, but the features will not work.
Click MAINTENANCE > Service Register to display the screen as shown. Use this screen to display the
status of your service registration. Go to myZyxel to activate the subscription.
Chapter 87 MAINTENANCE
for the new services supported when you purchase a Basic Routing License.
XS3800-28 User's Guide
687