Vrrp Summary - ZyXEL Communications XS3800-28 User Manual

72.3.2.2 Priority
Configure the priority level (1 to 254) to set which backup router to take over in case the master router
goes down. The backup router with the highest priority will take over. The priority of the VRRP router that
owns the IP address(es) associated with the virtual router is 255.
72.3.2.3 Preempt Mode
If the master router is unavailable, a backup router assumes the role of the master router. However,
when another backup router with a higher priority joins the network, it will preempt the lower priority
backup router that is the master. Disable preempt mode to prevent this from happening.
By default, a layer 3 device with the same IP address as the virtual router will become the master router
regardless of the preempt mode.

72.3.3 VRRP Summary

View the VRRP configuration summary at the bottom of the screen. Click NETWORKING > VRRP > VRRP
Setup to display the screen as shown next.
Figure 423 NETWORKING > VRRP > VRRP Setup: Summary
The following table describes the labels in this screen.
Table 288 NETWORKING > VRRP > VRRP Setup: Summary
LABEL
Index
Active
Name
Network
Virtual Router ID
Primary Virtual IP
Uplink Gateway
Priority
Add/Edit
Delete
Chapter 72 VRRP
DESCRIPTION
This field displays the index number of an entry.
This field shows whether a VRRP entry is enabled or disabled.
This field displays a descriptive name of an entry.
This field displays the IP address and subnet mask of an interface.
This field displays the ID number of a virtual router.
This field displays the IP address of the primary virtual router.
This field displays the IP address of the uplink gateway.
This field displays the priority level (1 to 255) of the entry.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
XS3800-28 User's Guide
534