Add/Edit Mac Forwarding - ZyXEL Communications XS3800-28 User Manual

Table 157 SWITCHING > NLB > MAC Forwarding (continued)
LABEL
Add/Edit
Delete

46.3.1 Add/Edit MAC Forwarding

Click Add/Edit, or select an entry then click Add/Edit in the SWITCHING > NLB > MAC Forwarding screen
to display this screen.
Figure 256 SWITCHING > NLB > MAC Forwarding > Add/Edit
The following table describes the labels in this screen.
Table 158 SWITCHING > NLB > MAC Forwarding > Add/Edit
LABEL
Name
MAC Address
VID
Port
Apply
Chapter 46 NLB
DESCRIPTION
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
DESCRIPTION
Enter a descriptive name for identification purposes for this rule. You can enter up to 32
printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ].
Enter a multicast or unicast MAC address of a cluster.
The last binary bit of the first octet pair in a multicast MAC address must be 1. For example, the
first octet pair 00000001 is 01 and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A and
03:00:5e:00:00:27 are valid multicast MAC addresses.
The last binary bit of the first octet pair in a unicast MAC address must be 0. For example, the
first octet pair 00000000 is 00 and 00000010 is 02 in hexadecimal, so 00:00:5e:00:00:0A and
02:00:5e:00:00:27 are valid unicast MAC addresses.
Enter the VLAN identification number. If you do not have a specific target VLAN, enter 1.
The Switch will forward traffic to ports in this VLAN group.
Enter the ports to which you want the Switch to forward the incoming NLB traffic.
You can enter multiple ports separated by (no space) comma (,) or hyphen (-). For example,
enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
In Stacking mode, the first number represents the slot and the second the port number. Enter 1/
1-1/24,2/23 for ports 1 to 24 for the Switch in slot 1 and port 23 for the Switch in slot 2, for
example.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
XS3800-28 User's Guide
342