Rapid Spanning Tree Protocol Status - ZyXEL Communications XS3800-28 User Manual

Table 185 SWITCHING > Spanning Tree Protocol > Spanning Tree Setup (continued)
LABEL
Apply
Cancel

54.4 Rapid Spanning Tree Protocol Status

The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status
in the navigation panel to display the status screen as shown next. See
more information on RSTP.
Note: This screen is only available after you activate RSTP on the Switch.
Figure 284 SWITCHING > Spanning Tree Protocol > Spanning Tree Protocol Status: RSTP (Standalone
Mode)
Chapter 54 Spanning Tree Protocol
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS3800-28 User's Guide
382
Section 54.1 on page 375 for