ZyXEL Communications XS3800-28 User Manual page 128

Figure 81 MONITOR > Port Status (Stacking Mode)
The following table describes the labels in this screen.
Table 30 MONITOR > Port Status
LABEL DESCRIPTION
SLOT This field appears only in Stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
Port This identifies the Ethernet port. In Stacking mode, the first number represents the slot ID and the
second is the port number. Please note that the default stacking ports (the last four ports of your
Switch) cannot be configured. They are reserved for stacking only.
Click a port number to display the Port Details screen.
Name This is the name you assigned to this port in the PORT > Port Setup screen.
Link This field displays the speed (either 100M for 100 Mbps, 1G for 1 Gbps, 2.5G for 2.5 Gbps, 5G for 5
Gbps, or 10G for 10 Gbps) and the duplex (F for full duplex or H for half). It also shows the cable
type (Copper or Fiber) for the combo ports. This field displays Down if the port is not connected
to any device.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port.
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol) and STP are in blocking state, it displays
BLOCKING.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on the
port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx kB/s This field shows the number of kilobytes per second transmitted on this port.
Rx kB/s This field shows the number of kilobytes per second received on this port.
Up Time This field shows the total amount of time in hours, minutes and seconds the port has been up.
Clear the Select Port, enter a port number and then click Clear Counter to erase the recorded statistical
counter information for that port, or select ALL Ports to clear statistics for all ports. In Stacking mode,
selecting ALL Ports clears statistics for all ports on this slot.
Chapter 15 Path MTU Table
XS3800-28 User's Guide
128