ZyXEL Communications XS3800-28 User Manual page 250

Chapter 35 Link Layer Discovery Protocol (LLDP)
Figure 170 PORT > LLDP > LLDP > Basic TLV Setting (Stacking Mode)
The following table describes the labels in this screen.
Table 107 PORT > LLDP > LLDP > Basic TLV Setting
LABEL DESCRIPTION
SLOT This field appears only in Stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
Port This field displays the port number. In Stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last four
ports of your Switch) cannot be configured. They are reserved for stacking only.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Management Select the check boxes to enable or disable the sending of Management Address TLVs on
Address the ports.
Port Description Select the check boxes to enable or disable the sending of Port Description TLVs on the ports.
System Capabilities Select the check boxes to enable or to disable the sending of System Capabilities TLVs on the
ports.
System Description Select the check boxes to enable or to disable the sending of System Description TLVs on the
ports.
System Name Select the check boxes to enable or to disable the sending of System Name TLVs on the
ports.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
XS3800-28 User's Guide
250