Add/Edit Multiple Spanning Tree - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Table 191 SWITCHING > Spanning Tree Protocol > MSTP (continued)

Revision Number

Use this section to configure MSTI (Multiple Spanning Tree Instance) settings.

54.9.1 Add/Edit Multiple Spanning Tree

Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > Spanning Tree Protocol > MSTP

screen to display this screen.

Figure 295 SWITCHING > Spanning Tree Protocol > MSTP > Add/Edit (Standalone Mode)

Chapter 54 Spanning Tree Protocol

Enter a number to identify a region's configuration. Devices must have the same revision

number to belong to the same region.

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to

save your changes to the non-volatile memory when you are done configuring.

Click Cancel to begin configuring this screen afresh.

This field displays the ID of an MST instance.

This field displays the VID (or VID ranges) to which the MST instance is mapped.

This field display the ports configured to participate in the MST instance.

Select an entry's check box to select a specific entry. Otherwise, select the check box in the

table heading row to select all entries.

Click Add/Edit to add a new instance or edit a selected one.

Click Delete to remove the selected instances.

XS3800-28 User's Guide