Vrrp Configuration Examples; One Subnet Network Example - ZyXEL Communications XS3800-28 User Manual

Table 289 NETWORKING > VRRP > VRRP Setup: VRRP Parameters > Add/Edit (continued)
LABEL
Apply
Clear
Cancel

72.4 VRRP Configuration Examples

The following sections show two VRRP configuration examples on the Switch.

72.4.1 One Subnet Network Example

The figure below shows a simple VRRP network with only one virtual router VR1 (VRID =1) and two
switches. The network is connected to the WAN through an uplink gateway G (172.16.1.100). The host
computer X is set to use VR1 as the default gateway.
Figure 425 VRRP Configuration Example: One Virtual Router Network
You want to set switch A as the master router. Configure the VRRP parameters in the VRRP Setup screens
on the switches as shown in the figures below.
Chapter 72 VRRP
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XS3800-28 User's Guide
536