Overview Interfaces - Agilent Technologies Infinity II SFC Binary 1260 User Manual

11
Hardware Information
Interfaces
Table 12 Agilent InfinityLab LC Series Interfaces
Module
Others
G7116A/B MCT
G7122A Degasser
The detector (DAD/MWD/FLD/VWD/RID) is the preferred access point for control via
N O T E
LAN. The inter-module communication is done via CAN.
• CAN connectors as interface to other modules
• LAN connector as interface to the control software
• RS-232C as interface to a computer
• USB (Universal Series Bus) as interface to a computer
• REMOTE connector as interface to other Agilent products
• Analog output connector(s) for signal output

Overview Interfaces

CAN
The CAN is inter-module communication interface. It is a 2-wire serial bus
system supporting high speed data communication and real-time requirement.
LAN
The modules have either an interface slot for an LAN card (e.g. Agilent
G1369B/C LAN Interface) or they have an on-board LAN interface (e.g.
detectors G1315C/D DAD and G1365C/D MWD). This interface allows the
control of the module/system via a PC with the appropriate control software.
Some modules have neither on-board LAN nor an interface slot for a LAN card
(e.g. G1170A Valve Drive or G4227A Flex Cube). These are hosted modules and
require a Host module with firmware B.06.40 or later or with additional
G1369C LAN Card.
160
CAN USB LAN
(on-board)
2 No No
No No No
RS-232 Analo APG
g (A) /
ERI (E)
No No No
Yes No A
Special
Requires a HOST
module via CAN
1260 SFC Binary Pump