Agilent Technologies Infinity II SFC Binary 1260 User Manual page 181

2 Set the Configuration Switch to DHCP either on the G1369C LAN Interface
Table 18
SW 4
ON
Table 19
SW 6
ON
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. OpenLAB CDS ChemStation Edition,
1260 SFC Binary Pump
Card or the main board of above mentioned modules.
G1369C LAN Interface Card (configuration switch on the card)
SW 5 SW 6
OFF OFF
LC Modules with 8-bit configuration switch (B-firmware) (configuration switch
at rear of the instrument)
SW 7 SW 8
OFF OFF
Lab Advisor, Firmware Update Tool) and use MAC address as host name,
e.g. 0030d3177321.
The LC system should become visible in the control software (see Note in
section "General Information (DHCP)"
Dynamic Host Configuration Protocol (DHCP)
SW 7 SW 8 Initialization Mode
OFF OFF DHCP
Initialization Mode
DHCP
on page 179).
12
LAN Configuration
181