12
LAN Configuration
Manual Configuration
3 Type
Table 20
Value
?
/
ip <x.x.x.x>
sm <x.x.x.x>
gw <x.x.x.x>
exit
4 To change a parameter follows the style:
5 Use the "/" and press Enter to list the current settings.
184
? and press enter to see the available commands.
Figure 27
Telnet Commands
Telnet Commands
•
parameter value, for example:
ip 134.40.28.56
Then press [Enter], where parameter refers to the configuration parameter
you are defining, and value refers to the definitions you are assigning to
that parameter. Each parameter entry is followed by a carriage return.
Description
displays syntax and descriptions of commands
displays current LAN settings
sets new ip address
sets new subnet mask
sets new default gateway
exits shell and saves all changes
1260 SFC Binary Pump