4
Troubleshooting
90
Vertical - Channel 1 on, 5 V/div scale, dc coupling, 0 V
•
position, probe factor to 1.0 if an AutoProbe probe is not
connected to the channel
Trigger - Edge trigger, Auto sweep mode, 0 V level, channel
•
1 source, dc coupling, rising edge slope, 60 ns holdoff time
Display - Vectors on, 20% grid intensity, infinite persistence
•
off
Other - Acquire mode normal, Run/Stop to Run, cursor
•
measurements off
Default setup screen
Figure 16
3 If your screen looks substantially different, replace the
system board.
6000 Series Oscilloscopes Service Guide