To Remove The Bottom Cover; Figure 48 Removing The Cover - Agilent Technologies 6000 Series Service Manual

To remove the bottom cover

T-10 Screw
6000 Series Oscilloscopes Service Guide
1 Turn off the oscilloscope and disconnect the power cable.
2 Turn the oscilloscope so the bottom is facing up.
3 Using a T10 screwdriver, remove 5 screws from the rear and
sides of the cabinet.
4 Slide the bottom cover back and up to remove.
Figure 48 Removing the cover
Replacing 6000L Assemblies
T-10 Screws
6
T-10 Screw
133