6
Replacing 6000L Assemblies
To remove the power shaft
C A U T I O N
144
1 Perform the previous procedures:
"To remove the bottom cover"
•
"To remove the power supply"
•
"To remove the fan"
•
2 Use a flat-blade screwdriver to gently spread the latch while
pushing the power shaft forward.
Twisting the latch too much could cause it to break!
Figure 57
Removing the power shaft.
3 Lift and remove it from the deck.
4 When reinserting the power shaft, push the shaft into the
power switch until the shaft snaps onto the switch.
on page 133
on page 138
on page 140
6000 Series Oscilloscopes Service Guide