To remove the power shaft
C A U T I O N
6000 Series Oscilloscopes Service Guide
1 Perform the previous procedures:
"To remove the cabinet"
•
"To remove the power supply shield"
•
2 Use a flat-blade screwdriver to gently spread the latch while
pushing the power shaft forward.
Twisting the latch too much could cause it to break!
Figure 40
Removing the power shaft latch
3 Lift and remove it from the deck.
4 When reinserting the power shaft, push the shaft into the
power switch until the shaft snaps onto the switch.
Replacing 6000A Assemblies
on page 94
on page 114
5
119