Troubleshooting The Oscilloscope - Agilent Technologies 6000 Series Service Manual

Troubleshooting the Oscilloscope

WA R N I N G
WA R N I N G
C A U T I O N
C A U T I O N
6000 Series Oscilloscopes Service Guide
The service policy for the Agilent 6000 Series Oscilloscopes is
assembly level replacement. If you need parts or assistance
from Agilent Technologies to repair your instrument, go to
www.agilent.com and locate the service facility for your area.
HAZARDOUS VOLTAGES EXIST — REMOVE POWER FIRST !
The procedures described in this section are performed with power supplied to the
oscilloscope and with the protective covers removed. Only trained service
personnel who are aware of the hazards involved should perform the procedures.
Whenever possible, perform the procedures with the power cord removed from the
oscilloscope. Read the safety notice at the back of this book before proceeding.
HAZARDOUS VOLTAGES EXIST — HIGH VOLTAGE IS PRESENT ON DSO6000L
SERIES POWER SUPPLY HEAT SINKS !
The power supply heat sinks of the 6000L Series oscilloscopes are at a high
potential. This presents an electric shock hazard. Protect yourself from electric
shock by keeping this area covered or by not coming in contact with the heat sinks
when the power cord is attached to the oscilloscope!
REMOVE POWER TO AVOID DAMAGE !
Do not disconnect any cables or remove any assemblies while power is applied to
the oscilloscope, or damage to the oscilloscope can occur.
AVOID ESD DAMAGE TO COMPONENTS !
ELECTROSTATIC DISCHARGE (ESD) can damage electronic components. Use
proper ESD precautions when doing any of the procedures in this chapter. As a
minimum, place the oscilloscope on a properly grounded ESD mat and wear a
properly grounded ESD strap.
Troubleshooting 4
73