To Remove The Cabinet; Figure 17 Removing The Cabinet - Agilent Technologies 6000 Series Service Manual

5 Replacing 6000A Assemblies

To remove the cabinet

94
1 Turn off the oscilloscope and disconnect the power cable.
2 Using the T20 TORX driver, remove the two screws from the
rear of the cabinet.
3 Using your thumbs, gently push on the rear-panel connectors
to slide the oscilloscope out of the cabinet.
T-20 Screw
Figure 17 Removing the cabinet
Gently push
on the connectors
6000 Series Oscilloscopes Service Guide
T-20 Screw