Replacing 6000L Assemblies - Agilent Technologies 6000 Series Service Manual

Agilent 6000 Series Oscilloscopes
Service Guide
6

Replacing 6000L Assemblies

To remove the bottom cover
To remove the front panel assembly
To remove the system board
To remove the power supply
To remove the fan 140
To remove the AC power input assembly
To remove the power shaft
This chapter describes how to remove assemblies from the
Agilent 6000L Series Oscilloscopes. After you have removed an
assembly, to install the replacement assembly, follow the
instructions in reverse order.
The parts shown in the following figures are representative and
may look different than what you have in your oscilloscope.
Tools Used for Disassembly
Use these tools to remove and replace the oscilloscope
assemblies:
• T10 TORX drivers
• 5/8-inch and 9/32-inch socket drivers
See how the Oscilloscope Parts Fit Together
An exploded view of the oscilloscope is included in the
Chapter 7, "Replaceable Parts," starting on page 145. It shows
the individual part numbers used in the assemblies, and shows
you how all of the assemblies fit together.
Agilent Technologies
133
134
136
138
142
144
131