Figure 11 6000A Series Start Up Sequence - Agilent Technologies 6000 Series Service Manual

WA R N I N G
6000 Series Oscilloscopes Service Guide
3 Connect the power cord to the rear of the oscilloscope, then
to a suitable ac voltage source.
The oscilloscope power supply automatically adjusts for input
line voltages in the range of 100 to 240 VAC. Ensure that you
have the correct line cord. The power cord provided is matched
to the country of origin.
AVOID INJURY.
Always operate the oscilloscope with an approved three conductor power cable.
Do not negate the protective action of the three conductor power cable.
• On 6000A Series models, press the power switch.
When the oscilloscope is turned on, the front panel LEDs
•
will light up in the sequence shown in
page 75.
Next the Agilent logo and advisory screen will appear on
•
the LCD before the trace display appears.
It will take about 3 to 4 seconds for the instrument to turn
•
on. The instrument will go through the basic self test to
make sure all the major hardware is working correctly.
5
Figure 11 6000A Series start up sequence
Troubleshooting 4
Figure 11 on
}
4
}
3
}
2
}
1
75