Agilent Technologies 6000 Series Service Manual page 139

6000 Series Oscilloscopes Service Guide
4 Using a T10 Torx driver, remove the 2 screws securing the
power supply to the chassis.
5 Using a flat-blade screwdriver through the hole in the
divider, gently pry the power supply board up enough to snap
the power supply board off the rear snap fastener.
6 Using a twisting motion, with a flat-blade screwdriver gently
snap the power supply board off the front snap fastener.
7 Reverse this procedure to install the power supply.
Replacing 6000L Assemblies 6
139