Configuring Telephone Settings - Nortel BCM50 Configuration Manual

Registering Nortel 20XX IP telephones

Configuring telephone settings

If you are not automatically registered to the system, you can configure your telephone settings to
allow you to access a system on the network. You will also need to perform these steps if your
IP telephone is not connected to the same LAN to which the system is connected.
Follow these steps to access the local configuration menu on a 20XX IP telephone:
Restart the telephone by disconnecting the power, then reconnecting the power.
1
After about four seconds, the top light flashes and
When the greeting appears, immediately, and quickly, press the four display buttons, one
2
at a time, from left to right. These buttons are located directly under the display.
Press the button sequence within 1.5 seconds or the telephone will not go into configuration mode.
• If
Manual Cfg DHCP(0 no, 1 yes)
configuration mode.
• If any other message appears, disconnect, then reconnect the power, and try to access the
configuration mode again.
Enter the network parameters, as prompted.
3
As each parameter prompt appears, use the keypad to define values.
Use the * key to enter the period in the IP addresses.
Press to move forward.
OK
NORTEL NETWORKS
Display buttons
appears on the screen, you successfully accessed the
BCM50 Device Configuration Guide
119
Section 2: DN records
appears on the screen.