Nortel BCM50 Configuration Manual page 97

DN records parameters
Table 3 Telephone line assignment fields (Continued)
Attribute Values
Caller ID set <checkbox>
Vmsg set <checkbox>
Note: Contact your voice message service provider to find out if your voice message service
works with BCM50, or if you have any problems with your service.
Priv. Received # These fields reflect the settings defined under target lines.
(Target lines only) These are the digit strings that the system uses to identify a call for this telephone.
Refer to
Pub. Received #
(Target lines only)
Actions
Add To add a line to a telephone:
1. On the System DNs table (Line access tab), choose the DN record where you want to
2. Under the Assigned Lines table, click Add.
3. Enter a line number in the dialog box.
4. Click OK to save the line to the list.
Delete 1. On the System DNs table (Line access tab), choose the DN record where you want to
2. On the Assigned Lines table, select a line you want to delete.
3. Click Delete.
4. Click OK to confirm the selection.
Description
This prompt only appears for target lines, and any analog lines that
provide CLID through an GASM8 (not all markets).
When enabled, the telephone displays call information when it is
available for a call. This setting also is used in conjunction with other
settings to create the alpha tagging feature. Refer to
tagging for name display (incoming)" in the BCM50 Networking
Configuration
When disabled, no call information is displayed for this line. Choose
this setting if the telephone does not have a display, or if you do not
want call information displayed to the user. Disabling this function
can reduce system resource requirements.
Limitation: Only 30 telephones can have this field enabled for any
given line.
Select whether an indicator shows on the telephone for a voice
message waiting on an external voice message system.
The line must appear on receiving telephone.
Note: the Message Waiting Indicator (MWI) is currently supported
exclusively by Meridian Mail and CallPilot.
MCDN note: If your system is part of an MCDN network connected
to a Meridian 1 system, and you are using the voice mail system off
the Meridian 1, you need to enable this field.
Analog lines connected to legacy analog ASM station modules, and
analog telephones attached to an ATA device, do not provide visible
message waiting indication. Analog telephones connected to a
GASM8 support message indicators, if the telephone is set up to
receive them.
"Trunk/Line Data, main panel" in the BCM50 Networking Configuration
add lines.
delete lines.
Guide.
BCM50 Device Configuration Guide
97
Section 2: DN records
"Using alpha
Guide.