7316E Digital Phone Button Defaults; Table 42 7316E Digital Phone Upper Button Defaults - Nortel BCM50 Configuration Manual

Default memory button programming for telephones

7316E digital phone button defaults

The default button assignments for the 7316E depend on the template applied.
Programming Records to identify the current button programming for each telephone or group of
telephones.
• This telephone has individual handsfree, mute and headset buttons, located under the dialpad.
Handsfree must be set to
• The current incoming call on this telephone defaults to the voice path last used. For example,
if you answered the previous call using your headset, the next call will come in over your
headset.
• Line numbering starts on button 09.
Note: The 7316E digital phone buttons are mapped differently than the 7316 digital
phone buttons. Therefore, if you replace a 7316 digital phone with a 7316E digital phone,
the button programming reverts to the default settings for the 7316E, losing any keys
programmed by the user at the telephone. Also, settings that are copied from one
telephone to the other may be in a different location on the 7316E. This is consistent with
how the system behaves if you switch any telephone model for a different model on the
same connector.
Table 1 7316E digital phone upper button defaults
7316E digital phone upper button defaults
Contrast
Show time
Blank
Blank
Auto for these buttons to work.
Btn #
01
02
03
04
Section 2: DN records
Btn #
05 Blank
06 (DID only) Sys Park
07 Send Message
08 Speed dial
BCM50 Device Configuration Guide
141
Refer to your