Capabilities And Preferences - Ip Terminal Details Tab; Figure 28 Capabilities And Preferences - Ip Terminal Details Panel; Table 31 Capabilities And Preferences - Ip Terminal Details, Dn-Unique Field - Nortel BCM50 Configuration Manual

108
Section 2: DN records
Table 9 ATA settings (Continued)
Attribute Values
Disconnect <check box>
Supervision
(GASM only)

Capabilities and Preferences - IP Terminal Details tab

This is a single-terminal display of the terminal information that is also shown in the Telephony
Resources IP Terminal panel. Refer to
Configuration Guide
Figure 9 Capabilities and Preferences - IP Terminal Details panel
The one unique field is described in
Table 10 Capabilities and Preferences - IP Terminal Details, DN-unique field
Keep DN alive <checkbox>
N0027146 [Publish Date]
Description
Default: not selected
If you have a modem or fax machine that does not automatically disconnect when
the caller disconnects, you can set this field to Y and the system will disconnect the
line from the device once it receives the disconnect signal from the far end. This
feature is supported only by ASM8+ modules.
Note: The line must be configured as supervised/guarded). Refer to
the BCM50 Networking Configuration
"IP telephone set details"
for a detailed description of the fields and buttons on this panel.
Table
This feature is only relevant to the Nortel Networks IP telephones (2XXX).
When selected, the system retains the IP telephone DN record even if the IP
telephone becomes disconnected. This occurs as long as the IP telephone
has completed the bootup process. This allows DN-specific features like Call
Forward No Answer and Call Forward on Busy to continue to function even if
the telephone is disconnected.
WARNING: If the system is reset, and the IP telephone is disconnected, the
feature remains inactive until the telephone is reconnected.
Note: A delay of about 40 seconds occurs between when the IP telephone is
disconnected and when Keep DN alive becomes active. During this period,
incoming calls get a busy signal or are rerouted to the prime set, depending
on system programming. The delay also occurs when the IP telephone is
reconnected to the system.
If not selected, the DN record becomes inactive if the IP telephone is
disconnected, which produces a
special features, such as Call Forward, are invoked.
Guide.
in the BCM50 Networking
31.
Not in Service
DN records parameters
"Properties" in
prompt if any of the