Nortel BCM50 Configuration Manual page 95

DN records parameters
Table 2 Line Access - System DNs table fields (Continued)
Attribute Value
*Private OLI
*If your system allows outgoing name and number blocking, the telephone must have a valid OLI.
Fwd no answer up to 24 digits
Fwd delay 2, 3, 4, 6, 10
Fwd busy up to 24 digits
Fwd all up to 24 digits
Description
Define the originating line identification number (OLI) which appears
on the telephone being called from this telephone over a private
network.
Note: On systems running DID, this field is automatically populated
with the DN.
On PBX systems, this field is only automatically populated if the DN
length and the Received # length are the same.
If the DN length or the Received # length are changed so they are
different from each other, this field is cleared.
Also refer to "Configuring CLID on your system" in the BCM50
Networking Configuration Guide.
Enter the number to which you want to redirect unanswered
incoming calls.
Define the number of rings before the system forwards an
unanswered call.
This heading only appears after you enter a Call Forward No
Answer number and press Enter.
Redirect incoming calls when this telephone is busy with another
call.
This setting is the same as using FEATURE 4 at a telephone. When
this feature is active, all calls to this telephone are forwarded to the
destination entered in this field.
If you are forwarding calls to a remote location, ensure that you
include the required destination/access codes.
A user can press FEATURE #4 to cancel this feature.
Section 2: DN records
BCM50 Device Configuration Guide
95