Programming Distinctive Ringing; Ring Volume - Nortel BCM50 Configuration Manual

156
Section 3: Features
• At the telephone: Use the rocker switch under the dial pad to change the sound levels through
your handset. This also changes the volume levels during handsfree calls.
Programming note: Handsfree speaker volume returns to the default value set at the telephone
after each call ends.

Programming distinctive ringing

You can program a line or a telephone to use a distinctive ring when alerting at a telephone. Ring
types are ordered in a hierarchy, and a call that is coming in on a line with a higher priority ring
than what is assigned to the telephone, will use the line distinctive ring. If the telephone has the
higher ring priority, the call will use the ring defined by the telephone.
Distinctive ring can also be defined for hunt group calls.
• System settings for lines: Telephony//Lines//preferences//distinct rings
• Programming distinct rings for DN records: Telephony//DN records//Line access tab//
Preferences subtab
• Hunt group: Telephony//Hunt group//
• Through the **CONFIG telset interface:
Lines//Trunk/line data//Distinct ring
Terminals and Sets//Capabilities//Distinct ring
System progrming//Hunt groups//Distinct ring
• At the telephone (for set distinct ring, only):
Press FEATURE *6.
1
Enter the ring type number (1 to 4).
2
Press HOLD.
3

Ring volume

Adjust the volume of your telephone any time it rings.
Press FEATURE *80 until the ring is at the volume you want.
N0027146 [Publish Date]
Telephony features