Nortel BCM50 Configuration Manual page 203

Display prompts and messages
Display prompt
Key: NNN = DNs#; SSS = second DN#; XXX = line number; YYY = second line number
Release calls
Restricted call
Restricted call
CANCL RETRY
Ring Again?
YES NO EXIT
Select a line
Select line out
QUIT
Select line(s)
QUIT ALL
Select line(s)
ALL OK
Send message?
YES NO
Set locked
Start of list
NEXT
Still in trnsfer
CANCL RETRY
Description of error or action
You tried to use a feature while you were on a call or had calls on hold.
Release the call or calls, before using the feature.
Silent monitor: You entered the silent monitor feature code on a telephone
that already has an active call. To continue, you will have to put that call on
hold, or release it.
The destination you selected for line redirection is restricted.
System programming has a restriction configured for the call you are trying
to make, such as time-of-day restrictions for some calls.
Transfer: You cannot transfer the call because of telephone or line
restrictions.
Press YES to use Ring Again. Press NO to send a message.
Either you have no prime line, or the prime line is in use, or the line
programmed for an auto dial number, speed dial number, or Hotline is in
use. Select a line and dial again.
Speed dial: There is no line related with the speed dial number you are
trying to use. Select a free external line or line pool and enter the speed dial
feature code again.
Line redirection: Select the line used to redirect calls out of the system.
Line redirection: Press the lines to redirect. To release a line selection, press
the line to redirect again. Press ALL to redirect all your lines.
Cancel redirection: Press the lines that no longer need redirection. The lines
light up when pressed. After you cancel redirection for a line you cannot
restore it by pressing the line again. Press ALL to cancel redirection for all
your lines. When finished, press
Line redirection: Continue to press the lines to redirect. Press
when finished.
Cancel redirection: Continue to press the lines that no longer need
HOLD
redirection. Press
Press YES to send a message. See Messages.
You cannot use the feature you selected because your telephone is locked.
Message: You are at the beginning of your list of messages. Press NEXT to
move through your messages.
Transfer: Complete the transfer in progress before you access a new
feature, answer another call or select an outgoing line.
HOLD
or OK.
or OK when finished.
BCM50 Device Configuration Guide
203
Section 3: Features
HOLD
or OK