Configuring An Analog Telephone; Table 19 Analog Telephone Customization - Nortel BCM50 Configuration Manual

Configuring telephones: Analog devices

Configuring an analog telephone

On each panel on the DNs list, add or modify settings to customize the telephone operations. The
following headings correspond to each panel.
Refer to the Programming notes in each section for configurations that are unique or specific for
ISDN telephones.
Table 1 Analog telephone customization
Affected field
Model
Name
Line appearances
Caller ID set
Answer DNs
Intercom keys
The following settings are the only capability settings that are valid for analog devices.
ATA Timer
ATA tone
ATA use
ATA Dvc
Set Disconnect Supervision
The following settings are common settings that are specific to analog telephones.
Handsfree/HF Answerback
Page settings
Receive short tones
Hotline
Setting
Other
Unique to each device or
device loop
Ring only
Y (connected to ASM8+
modules or target lines)
Ring only
two: not configurable
Keep short for Modems and
Fax machines
Y/N
on site
offsite works for devices
connected to ATA modules
only
modem/telephone
(ASM8+ connections, only)
Y for auto-answer modems
and fax machines
N for telephones
N
Page only (Y)
Can send pages but cannot
receive pages
Y (analog telephones, only)
"Assigning a pause for
external dialing for data
devices" on page 70
Panel name and link to common procedures
"System DNs - Line Access tab" on page 73
"Line Assignment and Line Pools" on page 76
"Configuring Capabilities & Preferences" on page 78
"Configuring telephone capabilities" on page 79
"Configuring telephone capabilities" on page 79
BCM50 Device Configuration Guide
69
Section 2: DN records