Figure 20 System Dns Table; Table 23 Line Access - System Dns Table Fields - Nortel BCM50 Configuration Manual

94
Section 2: DN records
Figure 1 System DNs table
Table 23 describes these fields.
Table 2 Line Access - System DNs table fields
Attribute Value
DN <read only>
Model <alphanumeric>
Name <alphanumeric>
Port <port number>
*Public OLI <up to 10 digits>
N0027146 [Publish Date]
Description
Refer to "Main panel tabs: common fields" on page
Refer to "Main panel tabs: common fields" on page
Refer to "Main panel tabs: common fields" on page
This number indicates the port number that this DN corresponds to.
A group of port numbers relates to a specific station module installed
in your BCM50. If you change the DN for a telephone, the port
number remains the same.
If you physically move a telephone with the relocation feature turned
on, the DN transfers to the new port, and the DN for that port
transfers to the vacated location.
This setting defaults to the DN of the device. The Public Network
Code concatenates to the beginning of this number to create the
entire public network number. The length of this number is
dependant on the country requirements.
This line identification number (OLI) appears on the telephone being
called from this telephone over the public network. Refer to
network settings" in the BCM50 Networking Configuration
North America: If the OLI contains the public network code, the
information in the Public Network code field is ignored. Therefore, it
is recommended that OLIs be programmed to the public received
number length, only. This would allow a global change if the Public
Network Code is changed.
Note: If line pools are not properly configured, an extension may
use a line with a network range that does not include the OLI of the
telephone, causing the network to present an incorrect CLID to the
called party.
Also refer to "Configuring CLID on your system" in the BCM50
Networking Configuration Guide.
DN records parameters
93.
93.
93.
"Public
Guide.